Table 1-46 List Of Parameters That Can Be Set For Each Rp Type Using Ipv6 Qos Information - Hitachi GR2000 Series Configuration Commands

Parameter
Parameters that can be set for each RP type have been determined. IPv6 QoS can be
executed using RP-C6, RP-D6,GR2000-1B, GR2000-2B, GR2000-2B+ and
GR2000-BH but cannot be executed using RP-A1, RP-C, and RP-D. The list of
parameters that can be set for each RP type using IPv6 QoS information is shown in
Table 1-46 List of Parameters that Can Be Set for Each RP Type Using IPv6 QoS
Information.
Table 1-46 List of Parameters that Can Be Set for Each RP Type Using IPv6 QoS
Item
Main Item Sub-Item
Flow All protocol IPs
detection
Protocol number
conditions
Protocol TCP
Protocol UDP
Protocol ICMP6
Source IP address
Destination IP address
DSCP
precedence
IP user data length
Source port number
Destination port number <Port_Destination>
ICMPv6 type
ICMPv6 code
User priority
Important packet
GR2K-GA-0014
Ver. 07-02
Information.
Parameter
ip
<protocol No.>
tcp
udp
icmp6
<IP_Source>
<IP_Destination>
dscp <DSCP_Value>
precedence
<precedence_Value>
{upper | lower}
<Length>
<Port_Source>
<ICMPv6_Type>
<ICMPv6_Code>
user_priority <No.>
premium
RP-A1 RP-C, RP-D
Input Output Input
Side Side Side
Filtering/QoS Information
RP-C6, RP-D6,
RP-CV, RP-DV
GR2000-1B/2B
Output Input Output
Side Side Side
1-85