Hitachi GR2000 Series Configuration Commands page 311

!
Caution: When 1 to 3 is specified in <Level>, the operation is the same as when 3 is specified.
Table 3-2
Level
9
8
7
6
5
4
1-3
This parameter limits the moment at which coldstart trap is issued. The moment
at which coldstart trap is issued during setting of this parameter is outlined in
the table below.
Parameter
limited_coldstart_trap
unlimited_coldstart_trap •
Default:
Range of value:
This parameter specifies the moment at which link up/down trap is issued. The
moment at which link up/down trap is issued during setting of this parameter is
outlined in the table below.
Parameter
Interface
Protocol
Default:
Range of value:
GR2K-GA-0014
Ver. 07-02
Trap System Message Levels
Meaning
Fatal failure.
Serious failure or greater.
RM failure or greater.
NIF failure or greater.
Standby system failure or greater.
Network system failure or greater.
Warning level or greater.
Moment at Which coldstart trap is Issued
• When the router starts (the router power is turned on or active RM
restarts).
• When active RM is switched to standby RM.
• When the current configuration definition information is changed using a
config copy command.
• When the configuration information (config ip command) of IP is added
and deleted.
• When the time is changed using a date command
When the router starts (the router power is turned on or active RM
restarts).
• When active RM is switched to standby RM.
limited_coldstart_trap
limited_coldstart_trap or unlimited_coldstart_trap is specified.
Moment at Which link up/down trap is Issued
• Traps are sent prompted by up/down in the physical interface.
• Traps are sent prompted by link connection and disconnection at the
protocol level.
protocol
interface or protocol is specified.
SNMP Information
3-3