Table of Contents
Advertisement
Connecting to a Video Imaging Device
1.
Make sure that the power switch of the monitor is turned off.
2.
Make sure that the power switch of the imaging device is turned off.
3.
Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this device and the
signal output terminal of the imaging device.
VCR #2
S-video/Composite video
Do not connect both
plugs at the same time.
Use either of them.
Video disc player
With DVI-STB and RGB component setup
NOTES:
1. Cables are optional, except when specified.
2. The SCART terminal Adaptor for (AV4) is optional.
3. If video equipment with an S video output terminal is used, cabling by the S video cable is recommended to provide
finer video quality. (If the S video input terminal and the video input terminal of AV3 connect to the monitor at the same
time, S video input would govern.)
4. If the adaptor is applied to AV4 input as shown in the drawing, it is impossible to receive RGB signal.
20 18
16
14
12
10
8
6
4
2
21 19
17
15
13
11
9
7
5
3
1
Adaptor
VCR #1
To component video
equipments.
Please use the connection
cable suitable for the terminal
form of video equipment.
REAR PANEL CONNECTIONS
Use if the
video
equipment
has an
S video
input terminal
20
DVD player
Set-Top Box
- Quick Links:
- Product Specification
Hide quick links:
Advertisement
Table of Contents
