4-3. Preparation for reading/writing data
1
With the power turned off, insert the CF card into the CF slot.
2
Turn on the power switch (1).
3
While pressing the TEST key, press the CF key to switch to CF card read/write mode.
4
Select the mode.
<Read/write mode list>
Mode No.
Symbol name
r 1
w 2
r 3
w 4
r 7
w 8
* The additional sewing data that can be use with this sewing machine is data that has been created for the
Z-8550A/Z-8560A.
[-SEd]
Additional sewing data is read from the CF card into the sewing machine. *
[SEd-]
Additional sewing data is written from the sewing machine to the CF card.
[-MEM]
Memory switch settings are read from the CF card to the sewing machine.
[MEM-]
Memory switch settings are written from the sewing machine to the CF card.
[-SyS]
Control programs are read from the CF card and used to update the firmware version.
[LoG-]
Error log data is written from the sewing machine to the CF card.
NOTE:
• Make sure the CF card is facing the correct way.
• Always be sure to keep the cover closed except when inserting
and removing the CF card. If this is not done, dust may get inside
and cause problems with operation.
MEMO icon illuminates.
* If no valid data can be found on the CF card,
the MEMO icon will not illuminate.
The mode number will appear in (1) of the main display, and
the symbol name for that mode will appear in (2).
* The initial mode is additional sewing data reading mode
(r1). (Refer to the <Read/write mode list>.)
The mode changes each time the key is pressed.
Setting items
Z-8550A, 8560A
4. USING CF CARDS
4453Q
0188B
0189B
0190B
24