Service Code; Care And Maintenance Instructions; Fouling By Copying Or Sending Fax Messages; Clean The Scanner Glass - Philips MAGIC 2 User Manual

Only use this function when absolutely necessary. If you
are satisfied with your changes to the factory settings you
should not use this function.
Function 45 (Service code) is used to delete some or all of your
changes to the factory settings. This function enables you to
partially or fully reconfigure your device. It is especially helpful
if you have modified settings but find that your fax machine
does not respond as expected.
After deleting some or all of your custom settings please rerun

EASY INSTALL.

The following codes are at your disposal:
This code erases all your modifications to the factory settings.
The fax machine will therefore react in exactly the same way as
on first installation.
When you enter this code, all your entered settings and data will
be erased, except for:
• your personal outgoing message on your built-in answering
machine
• received messages
• stored short dial numbers
• stored telephone book numbers
• your name
• your telephone number
Select MENU 45 and press OK. Enter the service code
(7117 or 7140). Press OK.
With </> you can select whether you really want to delete
your settings. Confirm with OK. Your fax machine will be
reset to its original configuration.
The scanner glass and rollers of your fax machine should be
cleaned of paper dust and scuff when necessary.
Before opening the fax machine, make sure that you are
electrically discharged by e.g. touching the metal housing
of a grounded appliance, a water pipe or radiator.
Use a soft, fluff-free cloth lightly moistened with a little
alcohol (96%). You can also use a special cloth for cleaning
fax machines, which is available on the market. Do not
allow any moisture to penetrate inside the device.
Carefully remove the scanner by pulling it upwards on both
sides.
Place the scanner in front of you with the scanning glass
surface face up.
Gently wipe the glass surface with a soft cloth (A).
Before you re-install the scanner, also wipe the scanner
compartment.