Easylink; Service Code - Philips Magic 3-2 User Manual

User Manual
4 Carefully remove the document either from the
front or the back.
5 Close the scanner cover on the left and right, mak-
ing sure it clicks into place.
6 Close the panel so that it also clicks into place.
7 Insert paper (see Installation / Loading paper).

Easylink

Easylink is used in conjunction with additional devices
connected to the same telephone line (e.g. cordless
phones). However, the additional phone must be set to
dual-tone multi-frequency method. If your telephone
connection requires the pulse dialling method, then
you would need to briefly reset your additional device
to use it. For more information about this, please see
the user manual for your device.
Starting fax reception
When you answer a call on the fax machine and recog-
nise that it is a fax (you hear a beep or no sound) press
START and hang up. The fax will be received.
34
When you answer using an additional phone and it
turns out to be a fax, you can start the fax reception by
pressing *5 and then hang up. The fax machine will
receive the fax.
Interrupt ringing
When you answer on an additional phone and the fax
machine continues to ring, this means that the addi-
tional phone is connected in parallel. You can interrupt
the ringing of the fax machine by pressing **.
Changing codes
Select function 34 by pressing MENU, 34, and then
OK. Enter two different codes and confirm each code
with OK. Each code should begin with * or #.
Please note that the three Easylink codes must be differ-
ent. Otherwise on the display appears: CODE not OK
v Only change the specified codes *5 and **
if absolutely necessary!

Service code

Function 45 Service code is used to delete some or all
of your changes to the factory settings. This function
enables you to partially or fully reconfigure your de-
vice. It is especially helpful if you have modified set-
tings but find that your fax machine does not respond
as expected.
v Only use this function when absolutely necessary!
If you are satisfied with your changes to the factory
settings you should not use this function.
After deleting some or all of your custom settings
please rerun Easy Install.
The following codes are at your disposal:
Code No. 7117
This code erases all your modifications to the factory
settings. The fax machine will therefore react in exactly
the same way as on first installation.