Troubleshooting; Energy Saving Switch; Power Cord - Black & Decker 900142 User Manual

TROUBLESHOOTING

Dispenser does not operate.
Make sure the power cord is properly connected to a working outlet.
•
Water is leaking.
Bottle may have a leak. Remove bottle and replace with new bottle.
•
If leak remains, remove probe from bottle and call 866-429-7566 for assistance.
•
No water is coming from the taps.
• Make sure the bottle is not empty. If so replace it.
Make sure to push the water controls in fully.
•
Cold water is not cold.
• It takes up to one hour after setup to secure cold water.
Make sure the back of the dispenser is at least 4 inches from a wall and there is
•
free airflow on all 4 sides of the dispenser.
Hot water is not hot.
• It takes 15-20 minutes after setup to secure hot water.
• Make sure the power cord is properly connected to a working outlet.
• Make sure energy saving switch is ON.
Dispenser is noisy.
• Make sure dispenser is positioned on a level surface.
Water tastes bad.
• Drain water from reservoirs and replace bottle with a fresh one.
• Sanitize dispenser per Proper Care & Cleaning instructions.
Nightlight Isn't Working
Make sure the power cord is properly connected to a working outlet.
•
• Bulb could be out. Call 866-429-7566 for assistance.
Water Isn't Pumping
Make sure the power cord is properly connected to a working outlet.
•
• Make sure the probe connection with the water bottle forms a complete seal.
• Make sure the door is closed.
The Cup or Glass on the Display are Blinking
This is normal. It indicates the dispenser is either heating or cooling water. See
•
page 8 for details.
Model # 900142: Page 11