Troubleshooting - Black & Decker 900149 User Manual

TROUBLESHOOTING

Dispenser does not operate.
Make sure the power cord is properly connected to a working outlet.
x
Water is leaking.
Bottle may have a leak. Remove bottle and replace with new bottle.
x
If leak remains, remove probe from bottle and call 866-429-7566 for assistance.
x
No water is coming from the taps.
Make sure the bottle is not empty. If so replace it.
x
Make sure to push the water controls in fully.
x
Make sure the probe connection with the water bottle forms a complete seal.
x
Make sure the door is closed.
x
Cold water is not cold.
It takes up to one hour after setup to secure cold water.
x
Make sure the back of the dispenser is at least 4 inches from a wall and there is
x
free airflow on all 4 sides of the dispenser.
Make sure energy saving switch is ON.
x
Hot water is not hot.
It takes 15-20 minutes after setup to secure hot water.
x
Make sure the power cord is properly connected to a working outlet.
x
Make sure energy saving switch is ON.
x
Dispenser is noisy.
Make sure dispenser is level.
x
Water tastes bad.
Drain water from reservoirs and replace bottle with a fresh one.
x
Sanitize dispenser per Proper Care & Cleaning instructions.
x
Nightlight Isn't Working
Make sure the power cord is properly connected to a working outlet.
x
Bulb could be out. Call 866-429-7566 for assistance.
x
Nightlight Is Flashing
This indicates bottle is empty. Replace bottle.
x
Model # 900149: Page 11