Switching On / Of The Unit; Faceplate Release; Sound Adjustment - AEG CS FMP200 Owner's Manual

OPERATION
SWITCHING ON/OFF THE UNIT
Switch on the unit by pressing any
button [except OPEN button (7) and
button (4)]. When system is on ,press
button (9) to turn off the unit.

FACEPLATE RELEASE

Press OPEN button (7) to detach the
removable faceplate.

SOUND ADJUSTMENT

Press SEL button (10) to select the
desired adjustment mode. The
adjustment mode will change in the
following order:
Volume Bass
By pressing the volume up button
or volume down button
possible Press SEL button (10) for
several seconds, it is activated as
cyclical mode of following functions for
user's selection.
TA SEEK or ALARM
M ASK D PI or ALL
BEEP 2' nd or O FF
a) TA SEEK OR TA ALARM
- TA SEEK mode:
When newly tuned station does not
receive TP information for several
seconds, the radio retunes to next
station which has not the same
station (PI) as the last station, but
has the TP information.
When TP information gets lost at the
current station for retune time which
is set by RETUNE SHORT (30 sec.)
or RETUNE LONG (90 sec.), the
radio start to retune to next same PI
station. When same PI station does
not catch in 1 cyclic search, the
radio retunes to next station with TP
information.
- TA ALARM mode:
When this mode is selected, any
automatic retune mode is not
activated. Only double beep sound
(ALARM) is output.
When newly tuned station does not
Treble Balance Fader
(12), it is
PI SO UN D or M UTE
RETUN E L or S
have TP information for several
seconds, beeps come out.
When TP information gets lost at the
current station for retune time, the
beep sound is out-putted.
When newly tuned station has no
RDS signal, "PI SEEK" is
suppressed somewhat.
b) PI SOUND or PI MUTE
While AF switching is implemented in
C201 station, AF can switch to 100
MHz, which is non genuine AF (where,
different PI with same AF) in short
"DIP".
If a car cruises that critical area back
and forth, an oscillation
phenomenon can be occurred,
because the different PI code can be
(11)
received from 100 MHz with "XXX"PI.
The car radio has special procedure
to reduce even this kind of
unavoidable situation however there
is a limit to be escaped from this
serious case perfectly.
In that serious case, 2 mode is
selectable as follows:
98
100
PI :C 201
- PI SOUND mode:
When above different PI sound (DIP)
is heard once in a while, the DIP's
sound will be heard for a short time.
- PI MUTE mode:
Under above same situation, a mute
sound will be heard for a short time.
c) RETUNE L or RETUNE S mode
The initial time of automatic TA search
or PI search modes is selected.
When PI information is not caught for
retune time, the radio starts to retune
to next same PI station.
When same PI station does not catch
1 cyclic search, the radio goes to last
station and waits for several minutes
until PI code is received.
9
90
100
PI :XXX