Loudnes; Display; Equalization; Liquid Crystal Display - AEG CS FMP200 Owner's Manual

OPERATION
- RETUNE L mode:
Selected as 90 seconds.
- RETUNE S mode:
Selected as 30 seconds.
d) MASK DPI or MASK ALL mode
The AF frequency (which has different
PI or NO RDS signal with high field
strength) is masked during checking
PI when the unit searches AF. The
unit doesn't search this AF (DIP) for
few minutes. In the case of the AF
of NO RDS signal with high field
strength, if the real AF is wrongly
masked as DIP by some interference,
the unit hesitates to search real Afs.
For this reason, the unit has the user
option (MASK DPI) which doesn't
mask the AF of NO RDS signal with
high field strength. In MASK DPI
mode, the wrong sound or long mute
(according to PI SOUND or PI MUTE)
can be heard from the AF station
which has NO RDS signal and of
which the field strength is higher than
that of the currently tuning AF (station).
But, these phenomenons are rare and
the user will hardly hear the wrong
sound in whole Europe.
- MASK DPI mode:
Masked only the AF which has
different PI.
- MASK ALL mode:
Masked the AF which has different
PI and NO RDS signal with high
field strength.
e) BEEP 2'ND, BEEP ALL, BEEP
OFF mode
The situation of beep sound is
selected. The 3 mode is selected as
also by pressing the volume up
button (11) or volume down button
(12).
- BEEP 2'nd mode:
The beep is only generated when
all allowed double key is pressed
long (1 sec).
e.g.
When preset button (14) is pressed.
When BAD/LOU button (13) is
pressed.
When AMS button (18) is pressed.
- BEEP ALL mode:
The beep is generated when
every key is pressed.
- BEEP OFF mode:
The beep is disabled.
LOUDNESS
Press BND /LOU button (13) for several
seconds to reinforce the bass output.
Press it for several seconds again to
release this function.

DISPLAY

Press DSP button (15) to operate as the
conversion of each display mode as
follows:
- In case of receiving a RDS station
In radio mode:
->PS ->CT ->FREQ ->PTY ->
In CD mode:
->CD ->CT ->PS ->FREQ ->PTY ->
- In case of no receiving CT or PTY
information, the display shows as "NO
CLOCK" or "NO PTY".
- In case of receiving a non RDS station
In radio mode:
->"NO CLOCK" ->FREQ -> "NO PTY" ->
In CD mode:
-> CD -> CT -> FREQ -> "NO PTY" ->
Each displaying time is several seconds,
and come back to 1 position after
several seconds.
Notes:
- CT = clock time
- FREQ = frequency

EQUALIZATION

Press EQ button (19) to turn on
equalization function and to select
desired audio mode. There are five
kinds of mode as below:
FLAT CLASSICS

LIQUID CRYSTAL DISPLAY

Exhibit current frequency and activated
functions on the display (8).
10
st
POP M ROCK M DSP OFF