Connecting To An Existing Network - Buffalo AirStation WHR-HP-G54 User Manual

To add an AirStation to a network without changing the existing LAN configuration,
proceed as follows:
1. Put the AirStation in AP mode by moving the switch on the bottom from AUTO to BRI.
2. Connect one of the AirStation's LAN ports to an existing router or switch on your
network.
3. Temporarily change your computer's IP address to an unused address on the
192.168.11.x subnet, with subnet mask 255.255.255.0.
4. Type "192.168.11.100" into a browser window to open the AirStation's Configuration
Tool.
5. In LAN Config, configure the following settings:
IP Address = [192.168.11.137] (Specify an unused network address from the existing
LAN.)
Subnet Mask=[255.255.255.0] (Use the same Subnet Mask as the existing LAN.)
6. Restore your PC's IP address settings to their original values.
Connecting to a Preexisting Network