Ipmi Commands - HP Integrity rx2600 Operation And Maintenance Manual

Simple Commands
Simple IPMI commands enable you to control the BMC interface, view logs, get help, and
change your password.
To run simple BMC commands, follow these steps:
1. Enter the command followed by any required options. (The table below describes the simple
commands.)
Enter
2. Press
3. If prompted for additional information, enter the information and press
cli> c
Type the new password> ****
Retype the new password> ****
New password confirmed.
cli>
Command Syntax Options
C
FPL
H
INFO
LOC [0, 1]
P [0, 1]
Q
RS
SD
SE

IPMI Commands

IPMI commands enable you to communicate with and configure various components of the
server. IPMI commands are available only to users with Admin level access.
CAUTION: DO NOT run BMC IPMI commands unless you are experienced with the IPMI specification. If
you make mistakes running these commands, you can accidentally delete or modify data and cause the
server to operate unpredictably or fail to operate.
HP Integrity rx2600 server and HP workstation zx6000 Operation and Maintenance Guide
.
Mode Description
Prompts user for User
new password
N/A User
N/A User
N/A User
0=off User
1=on
0=off User
1=on
N/A User
N/A User
N/A User
N/A User
Enables a user to change the password.
Reads the forward progress log. This log is
encoded and can be used by HP support
representatives.
Displays a list of BMC commands.
Displays the BMC firmware revision.
Turns the system locator LED on or off.
Forces server power on or off; does not shut
down using OS procedures. If you do not enter a
parameter, it displays the current power state.
Logs out a user; does not close the BMC session.
Resets the system.
Displays the SDR repository. This data is
encoded according to the IPMI spec and can be
used by HP support representatives.
Displays system event log (SEL). This log is
encoded and can be used by HP support
representatives.
System Configuration
Enter
. For example:
55