Table of Contents
Advertisement
Electrical Connection
The instructions given below are designed
specifically for a qualified installer and should
aid him or her to perform all installation,
adjustment, and maintenance operations with
absolute precision and in compliance with all
current legislation and regulations. We
strongly recommend that all operations for
the installation of your cooker be carryed out
by Qualified Personnel in accordance with
existing rules and regulations.
Electrical connection
Prior to making the electrical connection, make sure that:
— the protection fuse and the domestic wiring system
are suitable to carry the total electric load of the oven
(see rating plate);
— your domestic wiring system has an efficient earth
connection in compliance with rules and laws in force;
— the wall socket or the omnipole switch used for the
electrical connection can easily be reached after the
oven is built in.
This appliance is delivered without an electric supply
cable, therefore, you will have to fit to it a supply cable
with standard plug, suitable for the total electric load
shown on the rating plate. The plug is to be inserted into
a suitable wall socket. If you require a direct connection
to the electric network (mains), it will be necessary to fit
between the appliance and the mains an omnipole switch,
with a minimum gap between contacts of 3 mm, suitable
for the required load and in compliance with rules in force.
The green & yellow ground wire must not be interrupted
by the switch and it should be 2-3 cm. longer than the
other cables. The supply cable must in all cases be laid
out in such a way as to ensure that it does not reach at
any given point a temperature 50°C higher than the
ambient temperature.
Suitable power supply cables are the following types,
considering the respective necessary section of cable:
H07 RN-F, H05 RN-F, H05 RR-F, H05 VV-F, H05 V2V2-
F (T90), H05 BB-F.
Terminal block
The oven has an easily accessible terminal block, which
is meant to work with an electric single-phase rate of
230 V.
The Manufacturer disclaims any liability in case
these accident-preventing rules are not observed.
14
Advertisement
Table of Contents
