How To Use The Built-In Timer - Sharp CD-C491H Operation Manual

HOW TO USE THE BUILT-IN TIMER

Timer playback
Before setting the timer, make sure that the clock setting
is correct. (Page 10)
Load the compact disc or cassette for playback, that you
want to control with the timer.
REVERSE
MODE
FUNCTION
TIMER
ON/
STAND-BY
MEMORY
2 7
3
8
4
5
6
To change the programmed contents:
Start again from step 1.
To stop playback during timer playback:
Press the ON/STAND-BY button to enter the stand-by mode.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TIMER button once to turn on the timer mode,
f
"
REC" is not lit.
3
Within 10 seconds, press the MEMORY button.
If more than 10 seconds have passed, start again from
step 1.
4
Turn the jog dial to set the hour at which to start, and
then press the MEMORY button.
5
Turn the jog dial to set the minute at which to start, and
then press the MEMORY button.
6
Set the hour and minute for the OFF time, the same as
described in steps 4 - 5.
VOLUME
7
Press the FUNCTION button to select the desired function
Jog dial
(CD, TUNER, TAPE 1, TAPE 2, DVD 1, VCR 1, DVD 2,
or VCR 2), and then press the MEMORY button.
When the TUNER or TAPE 2 function is selected, go to
TUNING
step 8.
( ) When any other function is selected, go to step 9.
8
When TUNER is selected
Turn the jog dial to select a previously programmed radio
station, and then press the MEMORY button.
When TAPE 2 is selected
Press the REVERSE MODE button to select the reverse
mode, and then press the MEMORY button.
9
Rotate the VOLUME control to adjust the sound volume,
and then press the MEMORY button.
10
After the setting has been performed whilst the unit is on,
press the ON/STAND-BY button to enter the stand-by
mode.
The unit will display the time.
11
When the timer start time is reached, timer playback will
start.
The volume will increase until it is at the volume level
when the timer was set.
12
When the timer end time is reached, timer playback will
stop.
f
"
celled. The unit will enter the stand-by mode.
Notes:
Once the time is set, the setting is retained until a new
time is programmed.
The timer cannot control the component connected to the
DVD 1, DVD 2, VCR 1/AUX 1 and VCR 2/AUX 2 sockets.
To confirm the timer setting:
Press the TIMER button once.
The turn-on time and the turn-off time will be displayed.
To cancel timer operation:
Press the TIMER button repeatedly to turn off the timer, "
PLAY" will go out.
36
CD-C491H(SUK) TINSE0229AWZZ
PLAY" will appear. At this point, make sure that "
PLAY" will disappear, and the timer mode will be can-
f
f