Makita 9560C Instruction Manual page 6

ASSEMBLY
1. Wheel guard
2. Bearing box
3. Screw
4. Lever
1
1. Screw
6
The tools equipped with electronic function are easy to operate because of the
following features.
• Electronic constant speed control
Possible to get fine finish, because the rotating speed is kept constantly
even under the loaded condition.
• Soft start feature
Soft start because of suppressed starting shock.
• Overload protector
When the tool would be employed over the admissible load, it will stop
automatically to protect the motor and wheel. When the load will come to
the admissible level again, the tool can be started automatically.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing side grip (handle)
002979
CAUTION:
• Always be sure that the side grip is installed securely before operation.
Screw the side grip securely on the position of the tool as shown in the figure.
Installing or removing wheel guard
002980
1
CAUTION:
• The wheel guard must be fitted on the tool so that the closed side of the
guard always points toward the operator.
2
Loosen the lever on the wheel guard. Mount the wheel guard with the protru-
3
sion on the wheel guard band aligned with the notch on the bearing box. Then
4
rotate the wheel guard around 180 degrees. Tighten the lever to fasten the
wheel guard. If the lever is too tight or too loosen to fasten the wheel guard,
loosen or tighten the screw to adjust the tightening of the wheel guard band.
To remove wheel guard, follow the installation procedure in reverse.
002981