Circular Saw MODEL 5901B MODEL 5902B 004126 DOUBLE INSULATION I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
SPECIFICATIONS Model 5901B 5902B Blade diameter 235 mm at 90° 85 mm Max. cutting depth at 45° 60 mm at 50° 53 mm 4,100 No load speed (min Overall length 380 mm Net weight 7.0 kg 6.7 kg Safety class •...
SAFETY INSTRUCTIONS ENA001-2 WARNING: When using electric tools, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock and personal injury. Read all these instructions before operating this product and save these instructions. For safe operations: tion and changing accessories.
ADDITIONAL SAFETY RULES FOR TOOL ENB036-4 Wear hearing protection. Use Rip Fence. Always use a fence or straight edge guide when Keep Guards In Place and In Working Order. ripping. Never wedge or tie lower guard open. Check 10. Guard Against Kickback. (Fig. 1 & 3) operation of lower guard before each use.
Page 5
control which could cause personal injury. Fig. 4 illustrates typical hand support of the saw. Fig. 6 17. Never attempt to saw with the circular saw held upside down in a vise. This is extremely danger- Fig. 4 ous and can lead to serious accidents. (Fig. 7) A typical illustration of proper hand support, workpiece support, and supply cord routing.
FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Adjusting depth of cut CAUTION: • After adjusting the depth of cut, always tighten the lever securely. Loosen the lever on the side of handle and move the base up or down.
Page 7
• Use only the Makita wrench to install or remove the blade. To remove the blade, press the shaft lock so that the blade cannot revolve and use the wrench to loosen the hex bolt counterclockwise. Then remove the hex bolt, outer flange and blade.
Side grip (auxiliary handle) 004133 Install the side grip on the tool securely before operation. 1. Side grip Joint set (optional accessory) 004134 Attach the joint to the chip chute in the blade case and secure it with the screws. Remove the lever attached to the main unit and attach lever of joint set.
CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.