Step 6, Connect Ductwork; Step 7, Connect Electrical - GE Monogram ZV800 Installation Instructions Manual

Installation Instructions
WALL-MOUNTEDINSTALLATION--VENTEDTO THE OUTSIDE
[_ CONNECT DUCTWORK
• Install ductwork, making connections in direction of
airflow as illustrated.
• Push duct over the exhaust outlet and damper.
• Secure joints in ductwork with sheetmetal screws.
• Wrap all duct joints with duct tape for an airtight seal.
• Use duct tape to seal the flange connections.
CAUTION:
Do not use sheet metal
screws atthe hood flange connection. Doing so
will prevent proper damper operations, Seal
connection with tape only.
Ducttape
over seam
and screw
Air flow
io
PRUDENCE ."
-- Screw
II ne faut pas utiliser de vis autoraurdeuses _ la
connexion du collet de la hotte, Ceci emp_cherait
le bon fonctionnement du registre, N'utiliser que du
ruban adh_sif pour assurer I'_tanch_it_ du raccord.
[] CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING:
If house wiring is not 2-wire
with a ground wire, a ground must be provided by the
installer, When house wiring is aluminum, be sure to
use U.L, approved anti-oxidant compound and
aluminum-to-copper connectors.
ADVERTISSEMENT :
Si la maison n'est pas c_blee avec deux fils et un fil
de terre, I'installateur doit installer un fil de terre. Quand
les fils sont en aluminium, il faut prendre soin d'utiliser
des connecteurs aluminium _ cuivre avec une p_te
antioxydante approuv_e par Ui.
• Remove junction box cover and knockout.
• Use a conduit connector to secure the conduit to
the junction box.
• Connect white leads to branch circuit white lead.
• Connect black leads to branch circuit black lead.
• Connect green/yellow leads to branch circuit green
lead or bare ground lead,
• Secure all connections with wire nuts on each
electrical connector.
• Push wires into junction box and replace cover.
Be sure wires are not pinched.
• Secure electrical panel cover with original screws.
12