Honeywell Ademco VISTA-21iP User Manual page 47

THIS SECTION APPLIES ONLY TO RESIDENTIAL SYSTEMS
Manually 1. Should you become aware of a fire emergency before your smoke or
heat detectors sense the problem, go to your nearest keypad and
Initiating
manually initiate an alarm by pressing the panic key assigned for
a Fire Alarm
FIRE emergency for 2 seconds (see below). If a key pair has been
assigned for fire, press both keys at the same time. See the Using
the Panic Keys section below for further details.
2. Evacuate all occupants from the premises.
3. If flames and/or smoke are present, leave the premises and notify
your local Fire Department immediately.
4. If no flames or smoke are apparent, investigate the cause of the
alarm. The zone number(s) of the zone(s) in an alarm condition will
be displayed at the keypad.
Using the A key or key pair may have been assigned for manually initiating a
Panic Key(s) FIRE alarm. See the Panic Keys section for key assignments.
Assigned for For convenience, indicate the key or key pair assigned for fire below.
FIRE
In divi dua l Key s
Emergency
A
OR Key Pairs
DISPLAYS FOLLOWING MANUAL INITIATION OF A FIRE ALARM
Carbon
If installed, carbon monoxide detectors provide continuous protection.
If a high level of carbon monoxide is detected, an interrupted pulsed
Monoxide
alarm sound occurs at the keypads and the detector(s). Immediately
Alarms
move to a spot where fresh air is available, preferably outdoors. From
a safe area, call your security service provider for further instructions.
To silence the keypad sounding, press the OFF key. To silence the
detector, see its instructions.
Fire Alarm System
B C
Press the individual key assigned for fire for 2 seconds.
∗
1
and
OFF
READY
∗
#
and
READY
3 #
and
STAY
F I R E 9 5
ALPHA DISPLAY KEYPAD
(zone 95)
Press both keys of the
key pair assigned for
(zone 99)
fire at the same time.
(zone 96)
95 95 95 95
ALARM
FIRE
FIXED-WORD KEYPAD
(cont'd)
AC
– 47 –