Arming Or Disarming The Camera - HIKVISION Network Camera User Manual

User Manual of Network Camera
(3) Click
Note: The wireless alarm/PIR alarm triggered record will be started if the wireless
alarm or PIR alarm is triggered on the defined recording schedule, either when the
wireless/PIR alarm is enabled or not. Please refer to Section 6.2 for details about
configuring recording schedule.
Manual Alarm/Emergency Alarm
DS-2CD8464F-EI camera supports manual alarm by the remote control. It can be
manually triggered and linked to the audio warning if any emergency happens. You
can press and hold the manual alarm button on the remote control for 2 seconds to
trigger the audio warning manually.
Notes:
 The manual alarm is enabled and armed by default and not user-configurable.
 The manual alarm triggered record will be started if the manual alarm is
triggered on the defined recording schedule, and will be stopped in 10 seconds
after the manual alarm stops. Please refer to Section 6.2 for details about
configuring recording schedule.

5.6.10 Arming or Disarming the Camera

Purpose:
This section is for DS-2CD8464F-EI cube camera only. You can follow below steps to
configure all-day arming for the camera with the wireless alarm, PIR alarm, motion
detection, tamper-proof, etc.
Note: Manual alarm is enabled and armed by default and not included in this section.
 Arm the camera
Steps:
1. Enter the Remote Control interface:
Configuration> Advanced Configuration> System > Remote Control
2. Select Arm from the Arm/Disarm drop-down list.
3. Set the arming delay.
Note: Arming delay refers to a time delay to arm the camera after you set it to
arming status on this page. You can set the delay as 10 seconds, 30 seconds, 1 minute,
3 minutes or 5 minutes. You can also customize the delay time.
4. Click
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
to save the settings.
Arm the Camera
Figure 5-43
to arm the camera.
47