Cisco 500 Series Quick Start Manual page 7

• 8 data bits
• no parity
• 1 stop bit
• no flow control
Enter a user name and password. User names and passwords are
S 4
TEP
both case sensitive and alpha-numeric. The default username is
cisco, and the default password is cisco.
If this is the first time that you have logged on with the default
S 5
TEP
username and password, the following message appears:
Please change your password from the default
settings. Please change the password for better
protection of your network. Do you want to change
the password (Y/N) [Y]?
Select Y, and enter a new administrator password.
S 6
TEP
Make sure that any configuration changes are saved before
C
AUTION
exiting by issuing the command:
copy running-config startup-config
You are ready to configure the switch. Refer to the
Stackable Managed Switch Administration Guide
If you are not using DHCP on your network, set the IP address type
N
OTE
on the switch to Static and change the static IP address and subnet
mask to match your network topology. Failure to do so may result in
multiple switches using the same factory default IP address of
192.168.1.254.
500 Series Stackable Managed Switches
Cisco 500 Series
for further information.
7