Dust Hood; Motor Cover - Grizzly ZX Instruction Manual

Dust Hood

The Model G1023Z Series comes with a 4" dust
hood and a cleanout door.
To mount the dust hood and cleanout door:
1. Mount the cleanout door into the square hole
on the lower left side of the saw base.
3
2. Using (4) #8 x ⁄
8
#8 Flat Washer, screw the dust hood to the
cleanout door.
3. Be sure to orient the dust hood so the 4"
flange is on the lower half of the dust hood
when installed as shown in Figure 11 .
Figure 11. Installing dust hood.
-20-
" Self Tapping Screws and
Cleanout Door
Self Tapping
Screw
Dust Hood

Motor Cover

The Model G1023Z Series motor cover is
designed to increase the efficiency of dust collec-
tion. The motor cover is packaged amd shipped
in a separate box. It is held shut by a
knob bolt as shown in Figure 12a.
Knob Bolt
Figure 12a. Installed motor cover.
G1023Z Series Heavy-Duty 10'' Table Saw
1 1
⁄ "-20 x ⁄ "
4 2
Motor Cover