Table of Contents
Advertisement
16
HINTS AND TIPS
ECOLOGICAL HINTS
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled wa-
ter, e.g. for steam ironing. If necessa-
ry clean the condensate before (e.g.
with a coffee filter) to remove possi-
ble small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes specified in the
programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the filter after each drying cy-
cle.
• Spin good the laundry before drying.
AVERAGE LAUNDRY WEIGHTS
bathrobe
quilt cover
man's work shirt
man's pyjamas
sheet
tablecloth
man's shirt
night dress
pillow case
towelling towel
blouse
ladies' briefs
men's underpants
napkin
tea cloth
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
the water conductivity you can adjust
the sensor to dry with the better results.
To change the sensor conductivity:
1. Turn the programme dial to availa-
ble programme.
2. Push at the same time 2 buttons
(see the illustration). Hold down un-
til one of the symbols come into
view on the display:
–
μS/cm
–
300-600 μS/cm
1200 g
–
700 g
μS/cm
600 g
3. Push the button again and again
500 g
until you set necessary level (see
the illustration).
500 g
250 g
200 g
200 g
200 g
200 g
100 g
4. To memorise the setting push at
100 g
the same time 2 buttons as are
specified in the point 2.
100 g
100 g
WATER CONTAINER FULL —
INDICATION
100 g
By default the indication
on. It comes into the view at the end of
the cycle or when the water container is
full. When you use an external equip-
ment to drain the container, the indica-
tion can be off.
low conductivity <300
moderate conductivity
high conductivity >600
is always
Hide quick links:
Advertisement
Table of Contents
