Hints And Tips - AEG T859M6OBC User Manual

24 www.aeg.com
Signal option is activated, the acoustic
signal sounds intermittently for 1 minute.
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programs). Flashing
symbol signals the execution
of the anti-crease phase.
Laundry can be removed
during this phase.
To remove the laundry:
1. Push the On/Off button for 2 seconds
to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:

11. HINTS AND TIPS

11.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which
are specified in the programs chapter.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• The water from the water container
can be used to iron the clothes. You
must first filter the water to eliminate
remaining textile fibres (simple coffee
filter is suitable).
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
• Inadequate default dryness level
settings. See chapter
default dryness level
• Room temperature is too low or too
high. Optimal room temperature is
between 18°-25°C.
10.13 Drum light on
Touch and hold down Silent button by
around 3 seconds.
The light inside the drum is on.
11.2 Adjustment of default
dryness setting
HOW TO ACHIEVE THE BEST DRYING:
1. Try to adjust the dryness level options
OPTIONS: Dryness Lev‐
(see chapter
el ).
2. If you want to further increase the
laundy dryness results, you can modi‐
fy the default dryness setting (see be‐
low). This adjustment will act on most
programs, except Wool, Duvet, Down
Jackets, Refresh programs if available
on the machine.
To change the default dryness setting:
1. Turn the appliance on.
2. Select 1 of the available programs.
3. Touch and hold down the Time Dry
and + Anti Crease buttons at the
same time.
One of the symbols appears on the
display:
Dryness
setting
Maximum
dryness
Adjustment of
Display symbol