Ripping - Grizzly G1019Z Instruction Manual

5. Install the table taper pin and table insert.
6. Install the blade guard.
7. Close the top and bottom covers.
Gullet
Tooth
Gullet Line
Figure 23. Side and front views of a standard
bandsaw blade.
The bandsaw blade is dangerously sharp.
Use extreme caution when working near the
saw blade. Failure to exercise care could
result in severe injury.
Model G1019Z 14" Bandsaw
Ripping is the process of cutting a board into two
or more thinner boards, generally in a direction
along its length. The maximum board width that
can be ripped is limited by the distance between
the blade and the support column. Maximum cut-
ting width for this bandsaw is 14
The important consideration when ripping is blade
Tooth
selection. Generally, the wider the blade, the bet-
ter. In most applications, a hook or skip tooth style
will be sufficient. Also, since most ripped lumber
will be planed or sanded smooth, you can choose
Gullet
blades with fewer teeth-per-inch. While blades
with fewer teeth-per-inch produce rougher cuts,
these types of blades offer larger gullet capacities
for clearing sawdust, produce less heat, and yield
more horsepower per tooth.
To perform ripping operations:
Blade Set

Ripping

1. The bandsaw must be adjusted correctly.
See "Blade Tension" and "Blade Tracking"
in Section 5.
2. The table must be square to the blade. See
"Table Adjustment" in Section 5.
3. Use the widest blade available. The blade
must also be in good condition.
4. Use a fence to guide work.
5. Draw a reference line on the edge of the
board.
6. Support ends of the board if necessary.
7. Feed work slowly and evenly.
1 ⁄ ".
4
-25-