Stand - Grizzly G1019Z Instruction Manual

Stand

To begin stand assembly, keep all the stand parts
within easy reach. To ease assembly, build the
stand upside down on a bench and then place it
upright on the floor.
1. Place the stand top upside down on your
bench.
2. Attach each of the four legs to the stand top
with carriage bolts, washers and nuts pro-
vided. Do not over tighten. The legs attach
to the outside of the stand top. See Figure
3.
3. Position the two upper stand braces and fin-
ish installing the carriage bolts. Do not over
tighten.
4. Attach each of the four braces to the stand
legs with carriage bolts, washers and nuts
provided. Do not over tighten. The braces
attach to the inside of the legs. See Figure 3.
Model G1019Z 14" Bandsaw
Figure 3. Completed stand assembly.
5
5. Press one ⁄ "-18 x
16
rubber foot. Use the washers and nuts sup-
plied to attach a rubber foot onto each of the
stand legs.
6. Flip the stand right side up and place on the
floor. Check to see if the stand is symmetri-
cal from two adjacent sides. Adjust if nec-
essary and tighten all nuts.
1
⁄ " hex bolt into each
2
-11-