Bandsaw Unit; Motor - Grizzly G1019Z Instruction Manual

Bandsaw Unit

This bandsaw is relatively heavy and awk-
ward to handle. We strongly recommend
that you get assistance. The bandsaw unit
is also very unstable until it is permanently
mounted to the stand. Use care so the
bandsaw unit does not tip.
1. Place the bandsaw on the stand and align
the four holes in the base over the four
mounting holes in the stand.
2. Secure the bandsaw base to the stand with
the four hex bolts, nuts and washers provid-
ed. See Figure 4.
Figure 4. Bandsaw mounted to stand.
-12-

Motor

The motor attaches to the back of the lower band-
saw unit. To install the motor:
1. Slide the motor pulley onto the motor shaft
so the larger diameter pulley is closest to
the motor. Line up the keyways and slide
the key into the keyway. Insert the setscrew
and tighten. Pulley alignment will be done in
Step 5.
2. Support the motor and insert the motor pul-
ley through the hole in the back of the band-
saw unit.
3. Align the mounting holes and attach each of
three cap screws, lock washers and fender
washers through the bandsaw unit and into
the motor. Leave the cap screws loose for
motor adjustment. See Figure 5.
4. Slip the V-belt onto the grooves of the wheel
and motor pulleys. Remember, this is a two
speed bandsaw. Be sure that the pulleys
you choose are aligned. Do not try to force
the V-belt onto non-aligned grooves. See
"Changing Speeds" in the Operations sec-
tion to select the proper speed.
Figure 5. Cap screws securing motor.
Model G1019Z 14" Bandsaw
Cap Screws