Installing Back Stop; Connecting To Dust Collection System - Grizzly G0512 Instruction Manual

Installing Back Stop

To install the back stop:
1.
Use a machinists square to position the back
stop perpendicular to the platen, on the end
of the table that is near the ON/OFF switch.
2.
Secure the backstop to the table with three
3
#8 x ⁄ " Phillips head tap screws (as shown
4
in Figure 18).
Back
Stop
Figure 18. Back stop mounted on table.
-18-
Connecting to Dust
Collection System
The dust port can be connected to a dust collec-
tion system with a 4" hose. However, in order to
move the dust from the sander, the dust collec-
tion system must be able to move approximately
500 CFM where the hose connects to the dust
port. Note—This number is an approximation and
is used for estimation purposes only.
To connect the dust port to a dust collection
system:
1.
Slide the 4" hose completely over the dust
port as shown in Figure 19.
Figure 20. Dust port connected to dust
collection system.
2.
Tighten the hose clamp to ensure a snug,
sealed fit.
G0512 Edge Sander