Assembly
Step 2: Install Wheel Axle and Wheels
To install wheel assembly, you will need:
Wheel axle (1)
M12 x 16 mm long full-thread hex bolts (4)
M12 serrated flange nuts (4)
*
Axle bracket
(1)
Wheels (2)
M16 x 30 mm OD x 2.5 mm washers (2)
Snap pins (2)
12 mm open end wrench
Socket wrench with 12 mm socket
Pliers
†
* Two brackets are needed to install wheel axle. One bracket
comes already attached to wheel axle; other bracket is included
in accessory kit box.
† Not included.
1.
Install wheel axle brackets to frame using 16 mm long
full-thread hex bolts and serrated flange nuts.
1A.
Install pre-attached bracket to frame first.
NOTE:
Axle brackets are offset (one side longer than the other),
place with the short side up during installation (see Fig-
ure 8).
Install other bracket (included in hardware bag) to
1B.
frame.
FIGURE 7: Wheel Axle Attached to Generator
8
www.honeywellgenerators.com
†
†
On each end of axle:
Slide and push wheel onto axle.
2.
FIGURE 8: Slide Wheel onto Wheel Axle
3.
Slide a washer onto axle.
Slide snap pin into pre-drilled hole using pliers until
4.
fully seated.
FIGURE 9: Snap Pin Installation
Return generator to upright position (so that wheels
5.
and leg supports are touching the ground).
HW7000EH Portable Electrical Generator Owner's Manual