Tripp Lite B140-101 Owner's Manual page 16

Standard Extender/Splitter Installation
9
Connect the B140-1P0 DVI-D Single-Link connector to the monitor;
or, connect the B140-1P0-WP-1, B140-1A0 or B140-1A0-WP-1 to
the monitor using a Tripp Lite P561-Series DVI-D Single-Link Cable.
The Green RJ45 LED on the B140-1P0 and the Green LED on the
B140-1P0-WP-1 illuminate to indicate the unit is receiving power
from the monitor.
10
Repeat step 9 for each additional monitor you are connecting.
11
Turn on the power to the DVI source. The Orange RJ45 LEDs
illuminate on the B140-002, B140-004 and B140-1A0, and the
Orange LED illuminates on the B140-1A0-WP-1 to indicate the unit
is receiving a signal from the source. The image should now be
displayed on the connected monitors.
12
If necessary, use the Equalization control on the B140-1A0 or
B140-1A0-WP-1 to adjust the video image. Note: An improper
Equalization setting can cause the monitor not to display a picture
at all. Try each Equalization setting until an acceptable image is
displayed.
201110026-93-3094-EN.indd 16
16
11/3/2011 11:37:10 AM