NETGEAR MBRN3000 User Manual page 8

Mobile Broadband Wireless-N Router MBRN3000
Table 1. LED and Front Panel Button Descriptions
LED LED Activity
Solid green
Solid Red
Power
Off
Restore Factory Settings
button
Solid green
Blinking green
LAN
(Ethernet)
Off
Off
USB
Solid blue
Blinking blue
Solid green
Solid red
Internet
Blinking green
Blinking green and red
Off
Solid green
Blinking green
Wireless
Off
Solid green
Blinking green
WPS
Off
Button Description
Turn the wireless radio in the router on and off. The wireless radio is on by default. The
LED located below this button indicates if the wireless radio is on or off.
Wireless
Press this button to open a 2-minute window for the router to connect with other
WPS-enabled devices. For more information, about using the WPS method to implement
WPS
security, see
page 19.
Solid green. Power is supplied to the router.
POST (Power-On Self-Test) failure or device malfunction
Power is not supplied to the router
Press button for 6 seconds. Power LED lights briefly. When
released, the LED blinks red three times and then turns green
as the gateway resets to the factory defaults.
The Local port has detected an Ethernet link with a device.
Data is being transmitted or received.
No link is detected on this port.
No USB device is connected.
•
An error has occurred with the device.
•
USB device is ready to use.
Data is being transmitted or received.
There is an Internet session.
No Internet connection.
Data is being transmitted over the USB port.
Traffic meter limit has been reached.
No Internet connection detected or device in bridged mode.
Indicates that the Wireless port is initialized.
Data is being transmitted or received over the wireless link.
The Wireless Access Point is turned off.
WPS wireless security is being enabled.
The device is in the 2-minute interval to synchronize security.
WPS is not being set or enabled.
"Using Push 'N' Connect (WPS) to Configure Your Wireless Network"
Description
Chapter 1: Connecting to the Internet
on
| 7