Restoring The Default Configuration And Password - NETGEAR RangeMax WPN824N User Manual

• Is your router set to a wireless standard that is not supported by your wireless adapter? Check
the Mode setting as described in
page 1-6.
If your wireless network appears, but the signal strength is weak, check these conditions:
• Is your router too far from your adapter, or too close? Place the computer that has the adapter
near the router, but at least 6 feet away, and see whether the signal strength improves.
• Is your wireless signal obstructed by objects between the router and your adapter? See
"Optimizing Wireless Performance" on page

Restoring the Default Configuration and Password

This section explains how to restore the factory default configuration settings that reset the
router's user name to admin, the password to password, and the IP address to 192.168.1.1.
Warning: These procedures erase all current configuration settings.
You can erase the current configuration and restore factory defaults in two ways:
• Use the Erase function of the router. To use the Erase function, see
Configuration" on page
• Use the restore factory settings button on the rear panel of the router. Use this method for cases
when the administration password or IP address is not known.
To use the restore settings button:
1. Locate the restore factory settings button on the rear panel of the router.
2. Use a sharp object such as a pen or a paper clip to press and hold the restore factory settings
button for about 5 seconds, until the Power light begins to blink.
3. Release the restore factory settings button, and wait for the router to restart, and for the Power
light to stop blinking and become solid green.
The factory default settings will be restored so that you can access the router from your Web
browser using the factory defaults.
Troubleshooting
RangeMax Wireless-N 150 Router WPN824N User Manual
"Viewing and Configuring Basic Internet Settings" on
5-14.
6-8.
v1.0, February 2010
"Erasing the
7-12