Table of Contents
Advertisement
Installing or removing battery cartridge
0
Always switch off the tool before insertion
or
removal
of
the battery cartridge.
0
To remove the battery cartridge, pull out
the set plate
on
the
tool
and grasp both
sides
of
the cartridge while withdrawing it
from the tool.
0
To insert the battery cartridge, align the
tongue on t h e battery cartridge with the
groove in the housing and slip it into
place. Snap the set plate back into place.
Be sure to close the set plate fully before
using the
tool.
0
Do not use force when inserting the battery cartridge.
If t h e cartridge does not slide in easily, it is not being inserted correctly.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge
so
that
the plus and minus terminals on the bat-
tery cartridge are on the same sides as their
respective markings
on
the fast charger.
Insert the cartridge fully into the port
so
that it rests on the charger port floor.
The charging light will come
on
and charg-
ing will begin. If the charging light does
not come on, press the reset button.
If
the
charging light goes
out
within
10
seconds
even after pressing the reset button a
couple of times, the battery cartridge is dead. (CAUTION : Wait for more than
5
seconds
after the charging light goes out
to
press the reset button again.) Replace it with a new
one. When t h e charging light goes out after about one hour, you may remove the fully
charged battery cartridge.
After charging, unplug the charger from the power source.
CAUTION
:
.Your
new battery cartridge is not charged.
You
will need to charge it before use.
0
If you try to charge a cartridge from a just-operated tool, sometimes the charging light
will not come on. If this occurs, let the cartridge
cool
off for a while. Then re-insert it
and try to charge it once more.
0
When you charge a new battery cartridge
or
a battery cartridge which has not been used
for a long period,
it may not accept a full charge. This is a normal condition and does
not
indicate a problem.
You
can recharge the battery cartridge fully after discharging
it almost completely a couple
of
times.
0
If you wish
to
charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
6
.
Advertisement
Table of Contents
