Linkstation Diagram - Buffalo HS-DGL Series User Manual

1. Power Button – The Power Button is used to
power the LinkStation on or off. The power on
process will take approximately 30 seconds to
a full minute to complete. During this time,
do not unplug the LinkStation from the wall
outlet. To turn the LinkStation off, press and
hold the power button for several seconds until
the Power LED light begins blinking. At that
time, stop pressing the button and shutdown
should complete within 30 seconds.
2. Power LED – The Power LED light will blink
during startup or shutdown, but otherwise will
remain lit up while LinkStation is powered on.
3. LINK/ACT LED – The LINK/ACT LED light
will light up if an Ethernet Cable is plugged in
that is attached to another device such as a
router, hub, or PC. Periodically, the LED will
blink. This blinking signifi es network activity.
4

LinkStation Diagram