Electrical Connections - AEG 20604 G Operating And Installation Manual

Electrical connections

Any electrical work required to install this hob should be carried out
by a qualified electrician or competent person, in accordance with
the current regulations.
THIS HOB MUST BE EARTHED.
The manufacturer declines any liability should these safety measures not be
observed.
This hob is designed to be connected to a 230-240V 50Hz AC electrical
supply.
Before switching on, make sure the electricity supply voltage is the same as
that indicated on the hob rating plate. The rating plate is located on the
bottom of the hob. A copy is attached on the back cover of this book.
The hob is supplied with a 3 core flexible supply cord incorporating a 3amp
plug fitted. In the event of having to change the fuse, a 3amp ASTA
approved (BS 1362) fuse must be used.
Should the plug need to be replaced for any reason, the wires in the mains
lead are coloured in accordance with the following code:
Green and Yellow - Earth
Blue
Brown
1) Connect the green and yellow
(earth) wire to the terminal in
the plug which is marked with
the letter 'E' or the earth
symbol
and yellow.
2) Connect the blue (neutral) wire
to the terminal in the plug which is marked with the letter 'N' or
coloured black.
3) Connect the brown (live) wire to the terminal in the plug which is
marked with the letter 'L' or coloured red.
Upon completion there must be no cut, or stray strands of wire present and
the cord clamp must be secure over the outer sheath.
A cut off plug inserted into a 13 amp socket is a serious safety
(shock) hazard. Ensure that the cut off plug is disposed of safely.
20
- Neutral
- Live
or coloured green
FO 0390