Replacing The Injectors - AEG 25658G-M Instructions For Use, Installation And Maintenance

13) REPLACING THE INJECTORS

The burners can be adapted to different types of
gas by mounting injectors suited to the type of gas
in question. To do this, first remove the burner tops
using a wrench "B". Now unscrew injector "A" (see
fig. 16) and fit a injector corresponding to the utilized
type of gas in its place.
It is advisable to strongly tighten the injector in
place.
After the injectors have been replaced, the
BURNERS
N° DESCRIPTION
1 RAPID
2 SEMIRAPID
3 AUXILIARY
4 ULTRA RAPID
CONVERSIONS
BURNER ARRANGEMENT ON THE HOT PLATE
OTHER MARKETS
NORMAL
PRESSURE
GAS
mbar
LPG 28 - 30
LPG 37
NATURAL 20
LPG 28 - 30
LPG 37
NATURAL 20
LPG 28 - 30
LPG 37
NATURAL 20
LPG 28 - 30
LPG 37
NATURAL 20
burners must be regulated as explained in
paragraphs 10. The technician must reset any
seals on the regulating or pre-regulating devices.
The envelope with the injectors and the labels
can be included in the kit, or at disposal to the
authorized customer Service Centre.
For the sake of convenience, the nominal rate table
also lists the heat inputs of the burners, the
diameter of the injectors and the working pressures
of the various types of gas.
NORMAL INJECTOR
RATE DIAMETER
g/h l/h 1/100 mm
218 88
214 88
286 115 Y
127 68
125 68
167 98 Z
73 50
71 50
95 72 X
244 93
239 93
319 124 Y
FIG. 16
15
NOMINAL
BY PASS
HEAT INPUT (W)
Min. Max. 1/100 mm
750 3000 41
750 3000 41
750 3000 41
500 1750 32
500 1750 32
500 1750 32
400 1000 30
400 1000 30
400 1000 30
1400 3350 62
1400 3350 62
1400 3350 62