Replacement Of Injectors - AEG 24968 G-m Use, Installation And Maintenance Instructions

Warning:
Conversion of this appliance shall only be
carried out only by authorised personnel.

11) REPLACEMENT OF INJECTORS

The burners are suitable for use with different gases.
To adjust to different gases it is necessary to change
the injectors.
A range of injectors are supplied with the appliance.
PROCEDURES
Removal of injectors
- Remove control panel (refer section 9).
- Loosen screw "A" and slide sleeve "B", away from
control valve (refer figure 21).
- Loosen the injector with the ring spanner "M" (refer
BURNERS
N° DESCRIPTION
LARGE
1
LEFT FRONT
MEDIUM
2
RIGHT REAR
SMALL
3
LEFT REAR
AUXILIARY
4
RIGHT FRONT
FISH BURNER
5
CENTER
WOK BURNER
6
LEFT FRONT
FIG. 21
CONVERSIONS
BURNER ARRANGEMENT ON THE HOB
OPERATING
PRESSURE
GAS
kPa
Propane 2.75
Natural 1.00
Propane 2.75
Natural 1.00
Propane 2.75
Natural 1.00
Propane 2.75
Natural 1.00
Propane 2.75
Natural 1.00
Propane 2.75
Natural 1.00
figure 22).
- Unscrew the injector with the open ended spanner
until there is clearance for the spring hook "P", to
engage the injector.
- Unscrew the injector completely.
Re-installation of injectors
- Select the correct injector.
- Hold injector with spring and offer it to the control
valve.
- Use spanner "M", to engage the threads.
- Remove spring "P".
- Tighten injector with ring spanner "M".
The technical details of the operating pressures,
injector diameters and rating for various gases are
scheduled below.
TABLE
PRIMARY AIR
DIAMETER
CLEARANCE "S"
INJECTORS
(FIG. 19)
1/00 mm
mm
9.00
9.00 150
9.00
9.00 145
9.00
9.00 100
1.00
9.00
9.00
9.00 136
complete 102
complete 170
9
HEAT
INPUT
MJ/h
90 11.2
11.2
90 10.2
10.2
60 4.9
4.9
50 4.0
90 4.0
83 9.2
9.2
14.0
14.0
FIG. 22
W
3100
3100
2950
2950
1450
1450
1050
1050
2600
2600
4000
4000