Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AEG C9500G-CMI
Summary of Contents for AEG C9500G-CMI
- Page 1 x GB x FR INSTRUCTIONS BOOKLET NOTICE D'EMPLOI ET ENTRETIEN mod.
- Page 2 GENERAL INFORMATION RECCOMANDATIONS AND PRECAUTIONS DESTINED TO THE END USER ENVIRONMENT PROTECTION ATTENTION: - Before using the appliance, do not forget to remove the plastic Packing disposal films protecting some parts of the appliance (facia-panel, parts in stainless steel, etc.) Sort packing into different materials (cardboard, polystyrene etc.) and dispose of them in accordance with local waste - Do not use the appliance as a space heater.
- Page 3 WORK-TOP USE USE OF THE GAS OVEN The first time the oven is used, it may give off acrid smells, caused by the first heating of isolating panels glue surrounding the oven (it is necessary to heat up the oven at the maximum USING GAS BURNERS temperature for about 30-40 minutes with closed door).
-
Page 4: Use Of The Electric Grill
Automatic electric ignition (optional) to ignite the burner. The oven door must always be completely open, before the In case there is no electric current, the burner can also be lighted burner ignition using a match. To ignite the burner, press the knob and turn it anti-clockwise to Automatic electric ignition (optional) the maximum position. - Page 5 Fig. 6 Fig. 6 A grill working light Fig. C Fig. D Fig. 6 B second TURNSPIT single level For utilization of the turnspit follow the instructions described . - Put the food in spit L (see fig. 7), paying attention to block it within SURFACE BAKING GRILL (480x240) the two forks F and to balance it, in order to avoid any unnecessary...
-
Page 6: Electrical Connection
This appliance must be earthed by law. Before connecting the appliance to the electrical supply, check that the earth system in your house is working correctly. Check that unit voltage and power, marked on the rating plate applied on the appliance, are correct for the supply. It is necessary that the feeding network is protected by a powerful switch able to disconnect completely the network with a contacts separation of at least 3 mm. -
Page 7: Care And Maintenance
CARE AND MAINTENANCE INSTRUCTIONS DESTINED TO THE USER Before cleaning the appliance, disconnect the gas general tap and unplug the appliance or disconnect power at the OVERALL DIMENSIONS main circuit breaker of the electrical system. Do not clean the appliance surfaces when still hot. IMPORTANT Periodically check the external gas connection hole and replace it when it shows any sign of deterioration. -
Page 8: Gas Connection
The appliance must be connected to the gas piping in a workmanlike way and in conformity with the regulations in force which lay down the installation of a safety valve at the end of the piping. For butane and propane a pressure reducer conforming to the standards in force may perform this task. -
Page 9: Gas Adjustment
GAS ADJUSTMENT If the appliance is foreseen to operate with a type of gas different from the suitable supply gas, proceed as follows: change the injectors, adjust the minimum flow of the burners, change the push-on connector. In order to change the work-top injectors, it is necessary to act as follows: remove the grids, remove burners and flame-spreaders "... -
Page 10: Appliance Maintenance
DISASSEMBLE OF WORK-TOP After having removed the knob once again, making sure that the thermostat rod has not been moved, screw slightly the above In case it is necessary to repair or replace the inside components, mentioned by-pass screw, to obtain a flame of 3 or 4 mm of length. act as follows:remove the glass lid from its position slipping off it upwards.