AEG KM 7.. Assistent Operating Instructions Manual page 10

5 Coarse rasp
For coarse rasping of vegetables
and fruit, etc.
6 Fine rasp
For fine rasping of vegetables,
fruit, chocolate, garlic, etc.
Preparing multifunction section
Fit safety cover (fig. 4)
The multifunction section can only be
put into operation when the mix con-
tainer is removed and the safety cover
for the mixer drive (figs. 1/S and 4) is
fitted.
0 Remove mix container as described
under "Mixer".
– The red warning lamp (fig 4/a)
flashes.
0 Place safety cover on mixer drive (mark
on mark
clockwise to the stop. The safety cover
is heard to engage. The mark
be above the warning lamp (fig. 4).
– The red warning lamp (fig. 4/a)
extinguishes.
Fitting all-purpose bowl (fig. 5)
0 Place all-purpose bowl (fig. 1/G) on
appliance (arrow
and turn counter-clockwise to the
stop. The all-purpose bowl can be
heard to engage. The two black arrows
must coincide.
Inserting spindle (fig. 7)
0 Place spindle (fig. 1/H) on spigot in
centre of all-purpose bowl.
Inserting tools
The following tools can be selected for
insertion:
• Whisking disk (fig. 1/Q) or
• Metal blade (fig. 1/P) or
• Plastic blade (fig. 1/O) or
• Insert holder (fig. 1/N) with cutting
insert (fig. 9)
) and turn counter-
must
on arrow
The insert holder must be fitted with
3
the appropriate insert depending on
the purpose of application (see "Insert-
ing cutting insert in insert holder").
0 Place desired tool on spindle.
– Whisking disk, metal blade and plas-
tic blade (fig. 8) mesh with the teeth
underneath on the spindle.
– The insert holder (fig. 11) rests on
the hexagonal spindle.
Preferably hold the insert holder with
3
two fingers in the two handle holes.
Fitting the cover (fig. 6)
0 Place cover (fig. 1/F) on the all-purpose
bowl (arrow
turn counter-clockwise to the stop.
The cover can be heard to engage. The
nose of the cover is then directly above
the handle, both black arrows must
coincide.
0 Insert stopper (fig. 1/E) in filling inlet.
Inserting cutting insert in insert
holder (fig. 10)
The appropriate insert must be placed
in the insert holder depending on use.
)
The inserts are contained in the hinged
3
accessories compartment (fig. 1/K) in
the motor casing.
The inserts are very sharp. They should
1
be held only with the handle!
0 Open accessories compartment by
pulling the handle (fig. 9).
0 Take required insert by the handle from
the accessories compartment (fig. 9).
0 Place the insert with the tip at the cen-
tre of the insert holder and place in the
recess of the disk (fig. 10).
0 To remove the insert draw slightly out-
wards with the handle and raise.
g
on arrow ) and
23