Yamaha FJR1300 Owner's Manual page 61

Specified spark plug:
CR8E (NGK) or
U24ESR-N (DENSO)
PERIODIC MAINTENANCE AND MINOR REPAIR
a. Spark plug gap
Before installing a spark plug, the spark
plug gap should be measured with a
wire thickness gauge and, if necessary,
adjusted to specification.
Spark plug gap:
0.7–0.8 mm
Clean the surface of the spark plug
gasket and its mating surface, and then
wipe off any grime from the spark plug
threads.
Tightening torque:
Spark plug:
12.5 Nm (1.25 m·kgf)
6-8
NOTE:
_
If a torque wrench is not available when
installing a spark plug, a good estimate
of the correct torque is 1/4–1/2 turn
past finger tight. However, the spark
plug should be tightened to the speci-
fied torque as soon as possible.
_
6