Yamaha FJR1300 Owner's Manual page 25

CAUTION:
_
If the multi-function display indi-
cates an error code, the vehicle
should be checked as soon as pos-
sible in order to avoid engine dam-
age.
_
This model is also equipped with a self-
diagnosis device for the immobilizer
system.
If any of the immobilizer system circuits
are defective, the immobilizer system
indicator light will flash, and then the
multi-function display will indicate a
two-digit error code (e.g., 51, 52, 53)
when the key is turned to "ON".
NOTE:
_
If the multi-function display indicates
error code 52, this could be caused by
transponder interference. If this error
appears, try the following.
_
INSTRUMENT AND CONTROL FUNCTIONS
ECA11790 1. Use the code re-registering key to
start the engine.
NOTE:
_
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
_
2. If the engine starts, turn it off, and
try starting the engine with the
standard keys.
3. If one or both of the standard keys
do not start the engine, take the
vehicle, the code re-registering
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.
If the multi-function display indicates
any error codes, note the code number,
and then have a Yamaha dealer check
the vehicle.
Clock mode
To set the clock:
1. Push the "SELECT" button and
2. When the hour digits start flashing,
3. Push the "SELECT" button, and
4. Push the "RESET" button to set
5. Push the "SELECT" button and
3-8
"RESET" button together for at
least two seconds.
push the "RESET" button to set
the hours.
the minute digits will start flashing.
the minutes.
then release it to start the clock.
3