Charging The Battery - Honeywell Dolphin 6110 User Manual
Mobile computer with windows embedded handheld 6.5
Hide thumbs
Also See for Dolphin 6110:
- User manual (72 pages) ,
- Quick start manual (12 pages) ,
- Operations & installation manual (13 pages)
Table of Contents
Advertisement
The following illustration shows how to install the ferrite on the cable. It should be placed approximately
1.57 inches (40mm) from the RJ45 plug. The cable should be looped around the core, as shown.
Charging the Battery
The base powers the terminal and fully charges its battery
pack in an average of 7 1/2 hours for a fully depleted battery.
It takes less time if the battery has some charge.
As battery packs charge, the charging circuitry follows the two-
step charging process (CC-CV) that is recommended for Li-Ion
batteries. The process monitors changes in temperature,
current, and voltage.
Inserting a Terminal
1. Install the battery pack in the terminal; see
tery
on page
2-1.
2. Power the base; see
Device
on page
10-4.
3. Slide the terminal into the terminal well making certain
that the terminal is seated properly.
4. The battery pack begins charging.
Ensure all components are dry prior to mating terminals/
batteries with peripheral devices. Mating wet components may cause damage not covered by the warranty
Powering the Dolphin HomeBase
Install the Bat-
.
10 - 5
Advertisement
Table of Contents
