Table of Contents
Advertisement
Figure 3-4
Follow
Table 3-4
to set the Recording Mode parameters.
Table 3-4
Field
RESOLUTION
CHANNEL
FRAME RATE
Note
The sum of the frame rate values from each channel cannot exceed the maximum
frame rates for a specific recording resolution. The total Maximum frame rate for
NTSC video are 120 fps (frames per second) for Quad and 30 fps for Full.
QUALITY
RECORDING
MOTION ZONE
MOTION
SENSITIVITY
SENSOR TYPE
PRE RECORD
POST EVENT
RECORD
Rev 3.01
Recording Mode Setup Screen
Recording Mode Setup Fields
Description
Sets the resolution to either
Selects the channel (camera 1–4) to apply the settings in this table.
Changes you make immediately take effect with the selected channel.
Sets the frame rate for the specified channel (choose from
1–30
fps).
Selects the recording quality for the specified channel. Options are:
NORMAL, HIGH, SUPER
Assigns the recording mode for each channel. Options are:
CONTINUOUS
BY MOTION
;
BY SCHEDULE
inputs);
Selects motion sensing zones. Options are:
FULL ZONE
PARTIAL ZONE
,
Note
If Partial Zone is selected (press SEL), the screen changes as
shown in
Sets the motion sensitivity for the specified channel, from:
1
9
to
(where 9 is the most sensitive setting)
Sets the type of sensor for the specified channel (see
page
8
for connection information). Options are:
None
N/O
normal open (ground connected to the input starts recording)
N/C
normal closed (ground connected to the input stops recording)
Enables/disables pre-event recording. Pre-event recording time is five
seconds and only intra-frames are recorded for pre-event recording.
Sets post-event recording time duration for the specified channel
(choose from 2–30 seconds).
FULL
Screen or
BY SENSOR
;
DISABLE
;
Figure
3-5.
15
QUAD
View.
OFF
(record based on sensor
SENSOR IN
Document 900.0399
or
on
08/08
Advertisement
Table of Contents
