6 INSTALL DECORATIVE DUCT COVERS
Pretap
2 Screw
Holes
Top Duct
Cover
• Pretap or drive decorative screw into the screw holes
on the support frame. This will make screw installation
easier.
• Separate the two decorative duct covers.
• Select the inside (top) cover, which has vent hole
pattern at the top.
• Slide the decorative duct cover over the support frame
and push to the ceiling.
• Attach to the hood support at the top with 2 supplied
decorative screws.
• Locate the stop screw in the envelope taped to the
front of the hood. Set aside.
Installation Instructions
Install Screw on
Each Side
Top Duct
Cover
Top Duct
Cover
Bottom Duct
Cover
• Slide the lower decorative duct over the installed upper
duct and push up, past the stop screw location.
• Install the supplied temporary stop screw in one of 3
holes in the support frame or the top duct cover to
prevent the bottom decorative duct cover from sliding
down.
CAUTION:
Failure to do so could result in personal injury or damage
to the duct cover.
9
Bottom Duct Cover
Stop Screw
Install Stop
Screw in One
of 3 Holes
The stop screw must be installed.