Table of Contents
Advertisement
REMOVE THE PACKAGING
The vent hood is packed separate from the required
accessory: ZXR858, ZXR859 or ZXR8510.
• Remove the frame, cover, parts box, side bars and
packaging.
• Remove junction box cover.
• Install strain relief onto junction box cover.
Check Installation Hardware
Locate the hardware accessory box packed with the
hood and check contents.
2 Phillips Head
Decorative Screws
4 Hex head
wood lag screws
(6mm x 2-1/2"
or
1/4 x 2-1/2")
4 (10mm) Nuts
and Lock Washers
3 Stainless Steel
Grease Filters
2 side bars with 4 Machine screws
Installation Preparation
4 Flat Washers
Front of Hood
Template
Check service manual
envelope taped to the front
on the hood to be sure it
contains one stop screw.
Leave this screw in the
envelope.
Check contents of the required accessory,
ZXR858, ZXR859 or ZXR8510.
Support Frames
With 8 Screws
And 8 Washers
3 Charcoal Filters
PLAN THE LOCATION
Determine the exact location of the vent hood.
• Use a plumb to check location to be sure countertop/
cooktop location below the hood will align exactly.
• The hood should project forward 1-1/2" beyond the front
edge of the cooking appliance. See illustration.
• Observe the recommended space between the cooking
surface and bottom of hood.
Front
Approx. 1-1/2"
Beyond Cooking
Surface
5
Mounting Screw Holes
Decorative Duct Covers
8 Frame Attachment
Screws with Washers
(attached to
accessory
support frames)
Ceiling
Hood
Ducting
Centerline
Hood
13-3/4"
27-1/2"
Cooktop
Countertop
Side View
Advertisement
Table of Contents
