Step 2, Install Upper Support Frame; Step 3, Install Lower Support Frame - GE Monogram ZXR8510 Installation Instructions Manual

2 INSTALL UPPER SUPPORT FRAME
• Install the plastic upper duct connector to the
upper support frame by inserting from the bottom
and snapping into the opening of the air deflector
(already installed).
• Secure the upper support frame to the ceiling joists
and/or cross framing with the 4 screws provided.
For maximum rigidity and strength, the screws must
be driven into the center of the joists and/or cross
framing.
• Check to be sure the support frame is level,
vertically and horizontally.
Upper
Front
Support
Of
Frame
Hood
Lower
Support
Frame
Installation Instructions
Air
Deflector
Plastic Upper
Duct Connector
Support
Frame
Opening
Check Level in
Both Direction
3 INSTALL LOWER SUPPORT FRAME
• Insert lower support frame (from required accessory
ZXR858, ZXR859 or ZXR8510) into the upper
support frame and loosely secure with 8 screws and
washers (4 on the front and 4 on the back sides).
• Adjust the lower support frame up or down to the
desired height above the countertop. Tighten screws.
Hood
Mounting
Flange
25-1/2" Recommended
*Note: 39-1/8" to top of hood flange can be increased up to
42" max.
**75-1/8" min to floor, 77-7/8" max.
Important: Again, check to be sure the support is
level in both directions. There is no way to level the
hood after the hood is secured to the frame.
7
Lower Support
13-5/8
*39-1/8"
**75-1/8"
to Floor
Countertop