Zanussi ZOP38903XD User Manual page 18

Installing the shelf supports
Install the shelf supports in the opposite se-
quence.
The rounded ends of the shelf supports
must point to the front.
Pyrolysis
Warning! The appliance becomes very
hot. There is a risk of burns.
Caution! If a hob is installed with the
appliance, do not use it at the same times
as the Pyrolysis function. It can cause damage
to the appliance.
1. Remove the removable shelf supports (if
applicable) and accessories from the appli-
ance. Refer to "Removing the shelf sup-
ports".
Caution! Do not let the removable shelf
supports stay in the appliance during the
Pyrolysis. There is a risk of damage.
2. Remove the worst dirt manually.
3. Fully close the oven door.
The cleaning procedure cannot start if you
do not close the oven door.
4. Press
again and again until the display
shows .
– The display shows P1 and
the other.
– An acoustic signal sounds as a reminder
to remove all accessories and shelf sup-
ports from the oven.
– The clock display shows 1:30.
– Duration
flashes.
5. When
flashes, press + or - to set the
necessary procedure:
• P1 - if the oven is not very dirty. The pro-
cedure is 1 h 30 min long.
• P2 - if the oven is more dirty. The proce-
dure is 2 h 30 min long.
6. Press
to start the procedure.
The bars on the symbol come on one by
one to show that the temperature in the
18
appliance increases. The symbol
es.
After some minutes the door locks. The
display shows the symbol
When the Pyrolysis is completed, the display
shows the time of day. The oven door stays
locked. When the appliance is cool again, an
acoustic signal sounds and the door unlocks.
To stop the Pyrolysis before it is comple-
ted, press
Setting the end time for the Pyrolysis
You can use the End
the start of the procedure.
1. Start the Pyrolysis procedure.
2. Press
the end of the Pyrolysis.
3. Press + or - to adjust the time for the end
of the Pyrolysis.
Oven lamp
Warning! Be careful when you change
the oven lamp. There is a risk of electrical
shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or deacti-
vate the circuit breaker.
one after
Put a cloth on the bottom of the oven to
prevent damage to the oven light and
glass cover.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the
lamp.
1. Turn the glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an appli-
cable 300 °C heat-resistant oven light
bulb.
Use the same oven lamp type.
4. Install the glass cover.
.
again and again until the symbol
flashes. The display shows the time for
www.zanussi.com
flash-
.
function to delay