Device Errors - Fujitsu fi-7160 Operator's Manual

Chapter 8 Troubleshooting
Error Error messages
code
U7:B9 Imprinting area Adjust the imprinting start position and
error the imprinter strings to fit the imprinting
(only when area in the document.
imprinter is For details, refer to "fi-718PR Imprinter
installed) Operator's Guide".
*1: When you open the ADF while the scanner is in standby, only an error
message will appear without an error code.
Also, note that buttons on the operator panel are disabled while the
ADF is open.
*2: When you open the imprinter print section while the scanner is in
standby, only an error message will appear without an error code.
Also, note that buttons on the operator panel are disabled while the
imprinter print section is open.

Device Errors

Resolution
The following are lists of device errors which require
troubleshooting by a service engineer.
■Internal and optical errors
Error codes beginning with the letter "E" are displayed.
E0:87
E1:7E
Error Error messages
code
FB carrier error Unlock the transport lock switch.
Unlock the transport For details, refer to "Installing the
lock switch. Scanner" in Getting Started.
(fi-7260/fi-7280)
Optical error (FB) 1 Confirm that the transport lock
If the problem persists
after turning the power
back on, please inform
your service provider
2 Turn the scanner off then back on.
of the above error
code.
(fi-7260/fi-7280)
Resolution
switch is not locked.
For details, refer to "Installing the
Scanner" in Getting Started.
If the problem persists, write
down the displayed error code
and contact your FUJITSU
scanner dealer or an authorized
FUJITSU scanner service
provider.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
133