Chapter 6 Daily Care
Ultrasonic sensor (× 2)/Document sensor (× 8)
Gently wipe the dirt and dust off the surface of the ultrasonic/document
sensors.
HINT
If it is difficult to clean, use a cotton swab.
Ultrasonic sensor
Document sensor
Feed roller (× 2)/Eject roller (× 2)
The power must be turned on to rotate the feed/eject rollers.
1 Turn on the scanner.
For details, refer to
"1.3 Turning the Power ON/OFF" (page
The [Ready] screen is displayed on the LCD.
2 Press the [Menu] button.
The [Settings Menu] screen is displayed on the LCD.
3 Press the [
] or [
] button and select [2: Cleaning], then press
the [Scan/Enter] button to confirm.
The [Cleaning] screen is displayed on the LCD.
4 Press the [
] or [
] button and select [2: Roller Wipe], then
press the [Scan/Enter] button to confirm.
A message is displayed on the LCD.
ATTENTION
Do not perform scanning from the scanner driver during
cleaning.
5 Open the ADF.
For details, refer to
"1.4 Opening/Closing the ADF" (page
When opening, the ADF might close
accidentally. Be careful not to have your
fingers caught when the ADF closes.
TOP
Contents
Index
Introduction
25).
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
27).
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
115