Mixer Operation - Casio CTK-6200 User Manual

Mixer Operation

To change mixer parameters
1.
Press the C-5 (MIXER) button.
• This causes the mixer screen to appear.
Currently selected setting
(MASTER, DSP, MIC (WK-6600 only), or A01 to A16/B01 to B16)
Parameter/Setting value
(when currently selected setting is A01 to A16/B01 to B16)
2.
Use the R-17 (u, i) buttons to select the
mixer parameter you want to change.
• You can select master (MASTER), effect (DSP),
microphone input (MIC) (WK-6600 only), or a part (A01
through A16, B01 through B16). The currently selected
setting is shown in the line two of the display.
• While a part is selected, you can toggle between
Group A and Group B by pressing both of the R-17 (u,
i) buttons at the same time.
Currently selected setting part
3.
Use the R-17 (t, y) buttons to move the thick
brackets (%) to the parameter you want to
change.
• The parameters that can be configured depend on the
currently selected setting. For details, refer to the
sections shown in the table below.
When this setting is
selected:
MASTER
MIC (WK-6600 only)
DSP
A01 to A16/B01 to B16
• When you move the thick brackets (%) to one of the
setting values of a part parameter, all of the part
parameter values of the group (A or B) to which the part
belongs are indicated by level meter black boxes.
4.
Use the dial or R-14 (–, +) buttons to change the
setting value.
• Pressing the R-14 (–, +) buttons at the same time
returns a parameter to its initial default setting.
• While the "Part" (part on/off) setting of a part parameter
is being configured, pressing both of the R-14 (–, +)
buttons at the same time will change the setting to "Sol"
(Solo). For details, see "Part Parameters" (page E-43).
5.
Repeat steps 2 through 4 as required to
configure other parameters.
6.
To exit the mixer, press the C-5 (MIXER) button
or the R-15 (EXIT) button.
• This exits the mixer screen.
• While master (MASTER), effect (DSP) or microphone input
(MIC) (WK-6600 only) is selected in step 2 above for
setting, you also can perform normal keyboard play (play
using layer, split, and Auto Accompaniment).
• While an individual part (A01 through A16, B01 through
B16) is selected in step 2 above, pressing a keyboard key
will sound only notes of the selected part. All other types of
performance operations (layer, split, Auto Accompaniment,
etc.) are disabled.
Using the Mixer
These parameters can be
configured:
MASTER parameters
(page E-41)
MIC parameters (page E-42)
DSP parameters (page E-41)
Part parameters (page E-43)
E-39