Removing The Battery; Charging The Battery - Casio Ravine 2 User Manual

REMOVING THE BATTERY

1. Slide the battery cover latch to the FREE
position in the direction of the arrow as
shown in the figure.
2. Insert your thumb in the right side groove
and pull up the battery cover in the direction
of the arrow.
3. Remove the battery by pulling the tab up.
Do not leave the removed battery in direct sunlight, or near heat sources such as an
open flame or stove. Otherwise, it may malfunction or cause a fire by bursting or
igniting. Do not hit, or exert excessive shock on the battery, as it can ignite or break.
24

CHARGING THE BATTERY

1. Connect the USB cable into the Wall/USB
Charger.
2. Plug the USB cable into the phone' s Charging/
Data Port. Plug the Wall/USB Charger into an
electrical outlet. The battery starts charging.
3. Disconnect the charger when the battery is
fully charged.
• Hold the small connector with the USB mark facing up. When inserting the
connector into the Charging/Data Port on the handset, hold the connector straight
against the port without tilting it vertically or horizontally and gently insert it.
If the battery connector is not properly aligned, damage could occur to the charging
connector and the phone may not be charged.
• Failure to completely reseal the Charging/Data Port cover after charging may allow
water or other liquids to enter the casing, damaging the handset.
Correct
Correct
01
02
03
04
05
Incorrect
Incorrect
25